Search results

Can you guys help me with a Husky 50 Rancher date code. Tag reads 6109866. Thanks for the help, looking at it tomorrow but I want it to be able to accept the 51/55 P&C's if its shot, sounds like earlier 50's will need machining to do that? Thanks again

Thanks guys, Jeff, sent you a PM

Looking for fuel tank halves for a Craftsman/Roper 3.7 early model. The manuel oiler version. Pic below. Thanks for looking

Looking for an early Craftsman/Roper 3.7. Parts saw/carcass. Need a part or two for project. Red one like the one below. Thanks

3400 rings(and/or piston)? Maybe I should just get your 3700 top end 25 DA oil pumps/check valves? Thanks

Morning folks, question. BIL dug his Dad's old Sears 3.7 out of the shed while we were there over Christmas. Told him I would work on it and see if we could get it started. Fun challenge. Cleaned it up a bit, dumped some fuel it in and presto! fired right up. P&C are perfect. Then the fun...

Thanks Rocket, I just resurrected an old thread due to working on my BILs Poulan crap saw

Thanks 67, gonna put a carb kit on it and will check the idle circuits. I know the saw is crap but its kind of a challenge. The other saw in his shed was a craftsman/roper 3.7 all complete, having fun with that too but no parts out there of course Any ideas on the Poulan over oiling?? I mean...

Good thread, hope you don't mind me resurrecting! So the BIL gave me his 2150 over the holidays to try to get it back running. One of the problems was that the oil pump gear "melted" and locked up. New pump installed and it oils all right, like a West Texas gusher!! Any ideas on how to...

Thanks Eric, will do, getting antsy, don't need to rush

Finished up with P&C, got new wrist pin bearing, ring and looks like plenty(.026) of squish for no gasket Opinions, Permatex red be OK to use for base of cylinder? I wanted to get some 1184 but couldn't find any local and I have the permatex. Pics yeah, muffler mod

Thanks guys, the scratch just stood out and is kind of dark. I think I caught it pretty early. But I figure get it smooth, new ring and see. CUINRV, will rebuild all the regular stuff except for main seals. Will run vacuum test when back together. Will run a bit and check compression also...

Found a Husky 55 to replace one the meth heads around here stole from the shed. Paid a little extra because the saw looked super clean, almost new(2000 model). Ran fine when bought, started to bog/run funny/low power when I got it home. Didn't run it much pulled the muffer, VIOLA!, scored...

Thanks Ray!!

Looking for IPL and Service Manual for Pro Mac 610

Perfect, thanks HT!!

Hello, FNG here. Long story, had all equipment stolen from shed. Decided to build a small saw while waiting on insurance company. Friend had a junk Husky 141. Has been fun to tear it apart. I know its not a pro saw but I am having fun with it. That's how I found this site! It has a great...