Search results

Thanks Mark, I think I'll take your advice and just try to pop out the seals and replace them. I have two ordered.

So on a Pro Mac 510, there's 2 Bearing Sleeve Assemblies (93763) that encase the Needle Bearing (213282) and Oil Seal (83859). When rebuilding the top end should these all be replaced? Can it be disassembled somehow? Thanks Bill

When changing a felt gas tank filter on a PM510 or SP40 the new filter is square, so do you just stuff it into position in the tank, fill the tank with a bit of gas and let it expand?

Or I'll just buy an adapter for the spark plug hole.

Thanks Mark, I'll see what I can come up with.

Hey there, I'm wanting to do a pressure and vacuum test on a Pro Mac 510. I've blocked off the exhaust port and the carb port with rubber and am ready to test, but where is the impulse line? Thanks Bill

OK, sounds good. Should I send you a private message on here with my address, or email it to you?

So $20 + shipping for everything? I'll take them if that's correct.

Are these still available?

The 380 IPL is here: http://files.chainsawcollectors.se/downloads/member/undee70ss/Mcc_Power_Mac_Series/ I'd guess the 360 is pretty similar.

I think you can find one here: http://files.chainsawcollectors.se/downloads/member/undee70ss/Mcc%2010%20Series/Mcc%20Mac%2010-10/