Search results

does the 5400 run? how much are you looking for?

I had thought of rigging up a load cell to try and get some comparative numbers for before/after mods. But an eddy brake.... you have my attention.

510 has the aluminum cases, 5100 the magnesium. Muffler mod/cat delete and put in a thinner base gasket for good measure :-)

It's a dolmar 6400. Where do I start?!? The saw ran, but I didn't put it in wood before tearing it apart. It sounded ok. Looks like someone used the saw to cut up plastic barrels or something. The cylinder was caked with melted shredded plastic, melted plastic goop everywhere. It couldn't...

Ebay special, on the bench for a new spark plug....

Easiest solution is to buy another 6400 and upgrade one with a 79cc top end. What happens next is you realize how much more power the 79cc saw has for the same weight as the 64cc saw. Then you go and buy another 79cc top end so you end up with two dolkita 79cc saws! Problem solved!

yikes... 9 year old thread brought back from the dead!

just a thought.... diameter of the 8pin sprocket is larger than the stock 7pin. check the rubber chip deflector for interference?

You should be able to spin the chain backward. Clutch binding up maybe when rotating backwards? If you take the bar and chain off can you spin the sprocket in both directions easily? Have you owned the saw since new? Adjuster should be pretty easy to operate... something sounds amiss.

I scored a brand new 5100 top end on fleabay for dirt cheap a while back, but now need to find a straight gassed saw :-)

Not sure how I missed this, but interested if still available. PMd

someone please buy this before my efco 7200s end up with a little brother

fwiw, I scored a barely used syncrowave 250 years ago on craigslist for pretty cheap ($1k iirc). I don't weld often these days, but when I do it's nice to be just a couple of toggles/turns/buttons away from welding almost anything.

Until they can figure out how to store more capacity using less weight and space, it will tough to use electric chainsaws for anything but light occasional work. Looking at the electric cars, a tesla model3 weighs 4,000lbs if you get the upgraded battery so you can get a 300+ mile range on a...

I see two man problems with battery powered saws... a) battery capacity b) recharge times. If you're doing occasional light work and only need something small an electric chainsaw might come in handy. I can't imagine how long it would take and how many battery swaps would be required to...

http://zamacorp.com/public/AloneImg/C1Q-DM29-EXP.pdf http://zamacorp.com/public/AloneImg/C1Q-DM26B-EXP.pdf I couldn't find the DM26 diagram without the "B". The rebuild kits have different part numbers and parts for the metering have different numbers. That being said, the body looks the...

sawagain lists it, part #168849-5

pull the plug, still hard to pull? take side cover off and turn over by rotating the flywheel? could it be the starter assembly binding?

price on the dolmars?

full oval. That's what real men use to cut with.