I have some slabs of black cherry I milled back in April and recently noticed armillaria (white fungus) on a couple of the slabs. Is there a way to get rid of this stuff or are these slabs just firewood?
I have an 8 foot section of western red cedar trunk I was planning on milling. The tree was cut down here in New York and It has a tunnel going right through the middle of the middle that looks like it was made by some sort of bug. Anyone know what caused this and if there’s a way to get rid of...
Not sure about tension side
I didn’t see the tree when it was standing but That would make sense considering the bad part is only on one side of the slab. I’m dreading it but I’m going to have to move them to a shady spot
The tree actually came down in a storm a couple of weeks ago and looked like it was starting to rot out at the base. These slabs came from about 10 feet up from the rot. They looked solid when first milled, nice tight grain and smooth. I think I may have them in a bad spot, direct sun all day
Didn’t have the tarp even covering them at first. Just put the tarp over the top Monday to keep rain and sun off
I think it’s getting sufficient air flow
Yea it’s just that one side
I noticed the one side of the slab the fibers looked darker and a little rough compared to the other side which was lighter and the grain looked tight
Haven’t check the ones below but hopefully it’s just that top slab
I also noticed some white spots starting to form...
So I milled some black cherry (6’LX36”Wx2.5” thick) last week and stacked it this past Saturday. I stacked it on top of a tarp laying on 6x6 blocks with 3/4x3/4 stickers in between each slab (6 in total). Had it uncovered until today when I checked on it and found the top slab started cracking...
Hi
Just got a good deal on an 066. Everything is oem except a metor piston and rings. The saw is an absolute beast and has no issues as far as I can tell but there are some cracks and small pieces that broke off on the bottom of the bar side of the crankcase. If this damage causes any trouble in...