Search results

looking for a Jonsered CS2172 and a CS2071 service manual and IPL please

Louder than stock for sure! But love the new sound.

My first attempt at a muffler outlet mod on my beloved 372xp. Sent from my SM-G965U using Tapatalk

Seems to rip,lets hope it holds up. Sent from my SM-G920P using Tapatalk

pretty good I think @ 170+psi with a base gasket.

OK! after one tank of gas here is the compression on my 357xp, this is on a cold motor full throttle.

Might be a long shot but thought Id try here first, Im looking for a 1977 Case W18 IPL and maintenance manual.

My 357xp seems to out run my 359 as of right now. I ran them side by side today and the 357xp rips... But then again the 359 doesn't have a muffler mod yet either, but does have a gasket delete. Hoping the 359 will have the same performance as the 357xp with a muff mod.

I havent checked it yet, I was going to run a tank of gas through it first. Sent from my SM-G920P using Tapatalk

I just bought a 357xp Meteor cylinder and piston kit from HLsupply for $130.00, OEM is $100 for piston and $173 for the cylinder.. where are these cheaper OEM parts?

Installed my new meteor cylinder and piston on my beloved 357xp. Tried to do a gasket delete but the piston hit the top of the cylinder not allowing a full stroke rotation. I have never had that issue before with any saw I have rebuilt with a base gasket delete. Squish with the gasket installed...

It spun off right at the end (closest to the case) of the threaded portion, leaving that part inside the clutch. I dont have a pic as I had to grind that end flat to seperate the cases and pull the bearing off. Sent from my SM-G920P using Tapatalk

I have Husqvarna 359 that broke the PTO/clutch end of the crank off, I noticed today while putting the saw back together that the faces of the clutch shoes are wearing uneven /weird and the clutch hub has some play on the bearing. My question is how much play should there be and could this be...

I'm in the same ball park, I already have a stihl MS260 pro, and a 346xp, 357xp, 359xp, 375xp,

http://www.lilredbarn.net/product-p/huck350-45mm-kit.htm this is the kit I used and I did the base gasket delete and mod'ed the muffler / opened it up a bit. Seems to run great right now but its not even broken in yet. Compression is about 165 right now but I dont have a tank of gas ran through...

Put a big bore kit on my 350 today, the stock piston is a 44mm and the big bore kit is a 45mm. Stock is 52cc @3.2hp what will might my cc's and hp be with this big bore kit ?

Ive been around a while Brett, just not on here as often as I used to be... Thanks from Fenton Mi.

Husqvarna 359 crankshaft.

looking for a MS 064 av IPL and service manual...Please and thanks you

I would think so too! Ive been trying to get the owner to look, its like pulling teeth, there has to be some nomenclature either tag or sticker or painted on number etc.. somewhere on it.