Search results

Gone

Prices lowered.

Bump. Offers?

Any takers? I’ll cover the shipping to the lower 48

Cleaning out the shed, have a few saws to move. EA4300F40B Ex rental saw. Fairly new top end, runs great, but this saw has some hours on it, and it shows. $150 Shipped to the lower 48. EA6100PREG damn near brand new, and looks it. New 20” B&C. $350 shipped to the lower 48 DCS6421 Sold

Saws #2 and 4 SOLD.

Got a few of these in conditions ranging from basket cases to rebuilt runners. Prices are vary and are plus actual shipping. Saw 1 (on the left) runner. Low hour saw, rebuilt bottom end. very clean. $300/OBO Saw 2 (center) runner. First generation DCS6421 gray top Version. It's seen some...

$125 shipped to the lower 48. Got one left

Got two DCS34 saws I'm not using, so they gotta go. Not even broken in. Got a decent bar for each, but no chain. $100 ea/OBO + shipping

Got a call from my pops. Said the 066 I sent him pulls too easy and won't start. After seeing his images of the scarred piston, I'm going to need a good jug to rebuild it for him. Anyone out there have a useable OEM top end they're willing to part with (with or without a piston?) I'd rather not...

Sold, pending funds,

Btw thanks Rich!

NWP kit bought from baileys

Time to sell one of my Makita Saws. This one is a DCS6401 with an 84cc top end. I got a carb modded by Rich (poleman) to go with it (will include stock carb too) Pretty clean saw all the way around. Asking $400PHO, $425 if I throw in a 20" B&C+ shipping to your location. PayPal as a gift, or you...

A trick I use to clean the needle bearing on the clutch hub is to spray WD-40 on the needles, then place the hub upside down on the end of the crankshaft. Spin it around a few times to makes sure it spins freely, then pull it back off and flush the bearing out again. Clean off the WD-40, and...

There is a risk of running the L side too lean, but at 1 turn out you should be in the ballpark, so I wouldn't worry with minor adjustment. If the throttle response is good and there's no bog on acceleration, back off the S screw to lower your idle RPM. However, from your description it...

I've got two of them on my bench right now. One needs a carb kit and a duckbill valve on the fuel cap (anyone know a part number for one that will work?) The second one is torn down for new seals and gaskets, but I need to track down a new loop handle and a missing fuel cap. These saw have a...

I've got one that matched the description exactly. Make me a fair offer and it's yours. It's missing filter cover and throttle linkage

Routine stuff would be the normal...air filter, fuel filter and spark plug, sprocket, etc. Also, cleaning the screen on the muffler, changing clutch springs when they wear out.

I got some old homelites too. Any interest?