Search results

I am not very familure with the clayton but I had a johnson that is simular to the hotblast 1557 and it was my understanding the you were not suposed to open the air inlet on the ash door unless you were burning coal....

the bearings on my 1950 are sealed

trere is no difference in the frame of a 3/4 ton and 1 ton ram van in that year, I had one for years and used it to pull my 24' enclosed race trailer weighing in a 8 thousand pounds. As far as brakes go if you are pulling a trailer over 5 thoudsand pounds without trailer brakes you are asking...

I heated my 2 story farm house with it fine as long as the wind was not blowing too hard, I have a new hotblast epa 1500 now that is great.

I had a Johnson furnace is that what you have?

I have had that same furnace for 2 seasons now and it is great. I had a older furnace before and this now one uses about a third less wood. Enjoy your new furnace.

with you being so close maybe I should bring you my 6401 and let you work your magic. I have to go to Columbus next week.....

The bar and chain can be brand new I just can not seem to get it right, been doing it for years. I can not cut straight with anything also can not draw a straight line and no I do not drink.

I do not get into things that big often, but I must say that I can not cut streight so I hate to have to make 2 cuts :)

The auction is almost over looks like someone is going to get a good deal. The high bidder right now is from Germany....

I realize you are loosing some tillable ground but doesent the windbreak and erosion qualities of the trees make up for that with higher yields throughought the rest of the field?

That is the same thing i noticed the electric bill went up a bit because the fan runs almost non-stop.

I have an older poulan 2000 that I use alot the only bad thing is the anti vibe is non existant.

I have made it through the winter using no propane I used to use about 4 500 gallon tanks a year. Last year I used about 2 tanks (I got the new hotblast last year)

yah if that is all it brings at the end of the auction that is what it will be sold for but I will not end the auction early for 300

I put a 500 dollar "buy it now on ebay" but I would sell it for 450 to an AS member plus shipping. But the auction starts at 300 and there is no reserve so you could take your chances.....

My brother and I usually go cutting together and he likes to use the 6401 for everything so I rarely get to use it. I want the 7900 just for felling, I used to keep a 32" bar on my 6800 but when I got the 143 I put a 24" bar on the 6800 and fell back in love with that saw. I would put a 36" bar...

Well I really want a 7900 so the wife said I have to sell 2 to get one. I put the Dolmar 111 and the 143 on the bay and now feel regret....

thank you

deos anyone know where the bar oil adjustment is on a dolmar 143