Search results

Scary stuff, the trees they found the EAB'S in is 5 mins from me. Lots of mature ash trees in this area.

I installed a WT-426 on my 026 pro, bolts right up and runs great, (thanks to an adjustable high speed) Got it from an older non pro 026. Good luck.

I do not know where in Pa. you are located, I have seen a chipper like that at an equipment service shop in Warrington Pa. that does repairs for Asplundh and Davey etc. The chipper has been sitting there for a couple of years now, not sure if its for sale.

There is a sawmill just north of Doylestown, I believe it is called Heacock lumber. I am not sure how well they pay but, the tree service that I worked for in the past would bring their logs there.

In the Philadelphia area, all of the utility clearance work is performed by Asplundh.

Andy, I just noticed the lack of an orange tip, I am sure you are correct. Sorry for the misunderstanding.

Chuck, Just rebuilt the carb on my 066 with a kit from baileys and was wondering the same thing. The saw is running fine with the new metal needle.

I have an old Red Max trimmer. Cant complain about this one, starts right up, has good power, etc.

Had one given to me apart in a box one time, that took a long time (and many beers) to figure out. That pic would have been a lot of help. Thanks.

I was starting to wonder if you forgot me, thank you in advance.

Get an exhaust hose like one at a service station designed to go through the garage door and hook it up to the truck and direct it towards the chipper.

Has to be the good old 044.

A large air leak will also mess up the impulse signal and not allow the carb to pump the fuel out of the tank causing a lean condition.

Moe: Use thinner oil when it is cold to prevent a sore right thumb. Dont ask me why I know.

My C-52 has a 28" bar on it with Stihl rs, seems to run it fine. Very loud saw.

In addition to my last post, Baileys did not have a kit available for my saw, it was an older model with the smaller piston pin diameter.

I just rebuilt an 044, the piston pin diameter is the difference between the two different piston and cylinder kits. Both of the cylinders had a hole for the compression release and came with a plug and gasket if it was not needed. The kit cost me (from the Stihl dealer) $250.00.

MS 260 I was at the local dealer today to try to purchase an adjustable carb for my 026 pro, and was told that the WT-426 carb was not available? Has anybody heard this one before?

I have a slightly newer Sears saw (orange in color) that looks just like that saw. It turns heads when you run it, but it weighs a ton, it is loud as he**, and slow. My saw has a 18" B+C on it.

I currently own 5 good running saws, always looking though. Stihl 044 Husky 345 Echo cs-3000 Echo cs-302 Sears ? old orange thing, real loud.