Search results

Here's what I've learned so far. Scumbag steals stuff. You report it stolen. Scumbag pawns your stuff. Police find your stuff and place a hold on it. If you want your stuff back, you pay the pawn note. If you don't pay the pawn note, you can wait for scumbag to pay restitution to the...

Update! Saws were found, and the cops have the thief on the run. But I'm told they are now evidence, and probably won't get them back anytime soon. Ain't that swell...

I've got some pictures from there, I'll see if I can't get them posted...

I am missing two saws, here are the descriptions: 2009 372xpw, new condition, new 24" Oregon bar 3/8 pitch 063 full comp square 2003 372xp, wrap handle, 32" bar 063 with faded husky logo barely visible, missing 2 screws on recoil starter, new muffler, wrap handle has been welded @ fuel tank...

If you remove your muffler and spark plug, you should be able to peek in the cylinder and spot any damage. It'll be hard to judge compression without the starter, they need to be turned over fairly fast to build compression, or "drop test"...

1 for a 372, 1 poss. 2 for 046/460

If it were me, I'd use it for parts. But I've got a few saws, and not enough parts. You might luck out and find another, one with a scorched cylinder for example, and make one out of two...

How long of a wait is it? I need a couple of bars...

They're not bad, a little less power than a 372 in stock form, but that's easily remedied. Parts are fairly easy to find, baileys will have most of what you need...

Sounds like you have a 575. Parts are plentiful, and a few interchange with the 372.

Half skip is a good compromise, skip tooth works best for those bar length cuts.

I warm up boots in the oven before applying sno seal, just have to make sure the wife not around....

Is the oiler working, or turned down? Fouled bar tip from lack of lube?

I gotta ask, was the chain brake on or off when you started the cut? You can be honest, more than 1 person has done this...

What did it smell like, the smoke?

I really like my hoffman's, so much I have 3 pair now. Used to wear wesco, but can't belly up to the price tag anymore...

I cut out the window openings on my shed with a 2100, 42" bar. And I have cut firewood with a skil saw...

Does the bar match? Sprocket noses need to match the pitch as well, should be stamped on either end of the bar...

My 576 was a turd out of the box, too. Bench tested fine, but bogged in wood. I opened up the muffler a bit, tuned on the carb a few times. After that it ran as well as my 372..

Grease the tip if ya want. The carb should be set to run fat from the factory...