Search results

Well, I don't know how I did it but I managed to post my MS200T for sale under an old account I had on here..... See MS200T F/S ,(by dastevoe) Wow, talk about confused :crazy: Steve

Has anyone (I am sure they have),built a Hutzl "kit saw" ? how did they turn out ?? Steve

Hey guys,looking at buying some hutzl parts off the web & wondered what delivery times are like & if they ship out of North America ?? Steve

So at the end of the day what were your timing #'s Brad ? and how much did you rotate the flywheel to advance ignition? Steve

"My back still aches when I hear that word" :) Steve

Four strokes no load then leans out. Saw ran great before new Caber rings, only put ring on because she was open to get ported. Steve

Tried that(no filter), didn't work. Still bogged. I pulled the carb & stripped it down again, it was clean as can be. Pressure & vac tested the a/m fuel line & no leaks. STUMPED !!!!! Steve

Here goes........ 038 mag, new rings, mild port job ex. opens 99* atdc,int. opens 75* btdc lower trans cleaned up.No base gasket,170# comp on new rings. Muffler mod. New carb kit,air filter,fuel line (aftermarket).Monkeyed with jets..lean,fat with no real improvement with the "bog"issue. Idles...

Yours are the only ones I can see. However I did find another thread ,200t Caruretor accel pump block off, which has pics. http://www.arboristsite.com/community/threads/200t-carburetor-accel-pump-block-off.238372/ Steve

Just wondering if the pics for this thread are available elsewhere ? I can't see anything. Steve

Nuff said.......................... Steve

Thanks very much Randy. Steve

Hey folks, got a 395xp to port. I've done a ton of Stihls so am new to the "BIG DOGS". Does anyone have info. to share on these, maybe a build thread I've been unable to find.......or PM me if you want to keep things on the "hush". Thanks, Steve

OK, so why not try out the 266 coil first before spending the $ ???? I see you have already ordered it so IMO, spare parts are good parts ! Good luck. Steve Did an edit as I misunderstood the context of underlined quote.......

YIKES, 56mm.............. not sure if the crank would take it.

Could be the muffler bearing............:eek: Couldn't help myself :dizzy:......... sounds like the coil Steve

Thanks guys, that's the input I was hoping for. I was pondering tac...98's method (feeling a bit lazy on the machining end), now I have Daves #'s, I am getting "less lazy" ;) Steve

Diggin' deep into the archives here !!!!!!!!!!!!! Has anyone got info. w/results on porting a Ms 360 Pro ?? I have one on the bench right now. Here are the #'s I have w/out gasket: Squish. .018" Ex. opens 105* Atdc 150* dur. Int. opens 80* Btdc 160* dur Trans. open 123* Atdc 114* dur 18*...

What about Simonizer , Nord of de border eh . Steve

Yes, and a few close buddies. I've never been good with "whiners" . Whenever $ is involved one or two of them will turn up :mad: Steve