Search results

again

Picture test

Here is some pics of my homemade OWB. Mac

I had a small bow on my 026 Pro and was satisfied with it. I now have it on one of my 361's. Mac

Thanks for the answers guys, I will try to get some pics today. I had a 51 and it was a wonderful saw, I am just way more familiar with Stihls. I also have a 41 I bought the other day. Mac

I was given a 61 the othe day. I am not a Husky guy but this thing looks pretty well built. I am going to clean it up a little and may end up keeping it. I checked the compression tonight and it is at 150 lbs.. The clutch spring is broke so I will have to get one. It came with a straight bar and...

About the question on what you use for the pipe I use EMT conduit 1/2" or 3/4". Mac

Thanks tree monkey it was the coil. I put the one off my 440 on and it runs like a new saw. Mac

Sorry to hear about the damage it could have been worse, I will send you some rep. Mac

If it were a air leak wouldn't it not run good at idle?? It cranks and idles fine it just will not rev up. I am leaning toward the coil too, I just did not know if it would partialy go out. Mac

The comression is fine. I will get some carb cleaner and clean the carb again. I even changed the decompression valve with no change. Mac

I have a 026 pro that I am working on for a buddy that was running fine. He run out of gas and filled up and said the saw starting acting like it is now. It cranks and idles fine but as soon as you give it throttle it acts like it is hitting a rev limiter and will not rev up. Like I said it will...

I am sorry to hear about the 660. Where are you located in NC? Mac

I had one of the Carlton bars and had to drill out the oil hole. I found out pretty quick that is was hardened steel and eat up a couple of bits to open it a little. Mac

I know $35 sounds good, but I am going to have over $100 in it. The biggest thing I am having to buy is the clutch side cover that was $50 from the dealer. I also had to buy a new drum bearing $8, a new inner chain gaurd, chain and clutch springs. I already had a 20" bar for it. I am not...

I did the mod myself, but welded up the factory hole. I made the new hole 9/16", just a little smaller than the inside diameter of the 3/4" conduit I used for the pipe. Thanks for the kind words. Mac

Why dont you do it yourself, it is not that bad. I used a piece of half inch conduit for my 026 Pro and 3/4 inch conduit for my 361's. Here are some of my 361 Mac

Carl dont feel too bad, it took me alot of years to get a deal like this and this is the best I have gotten. My second best deal is the 026 pro that I got for $60. Mac

Here are some pics of the 361 after very little cleaning and replacing the drum bearing. I did mod the muffler a little. Mac

I actually bead blasted the clutch and cleaned it well and it still done this, that is why I was thinking springs. As far as being unbelievable, that is why I have all the saws I have with not alot of cash spent. Mac