Search results

got em... Thanks !! Still looking for a Shop Manual and IPL for both the Mtronic and non-Mtronic...

Looking for IPL / Shop Manual / Operators Manual for Stihl MS 462 that covers both Mtronic and Non-Mtronic...

hey.... yours looks cooler than mine... the uni-strut should be a lot lighter than my rig... and it should hold up just as well... good looking fab job, and good idea using the uni-strut....

those pics were posted up in Jan 2010... still using it... Post up your pics when you get it done.... we would like to see em...

Thanks... Thanks much for that, rep sent...

service manual for Stihl MS 361 Looking for service manual for Stihl MS 361 any help appreciated.... Thanks...

Stihl FS86 looking for Stihl FS86 trimmer service manual I know I'm off chainsaw topic here, but if anyone would happen to have one, I would sure appreciate it... Thanks...

built my own... mine is for a 22 ton splitter, but you should be able to get the idea. It just sets on and off, no fasteners to undo, just set it on the brackets or lift off..

rep + Sent you some rep Wood Doctor... excellent post... Thanks for sharing...

I stand on the side of the motor... never had a split come that way... I shove em away from me, over on to the table...

pics Here is a pic showing some of the welds on my Huskee 22... I've had no problems with any welds...

Do you have an anti scald mixing valve installed? Sometimes they will act up on occasion...

Air in the lines? Check for air in your lines ... do you have a valve in your system to bleed any air out?... I didn't see one in the pics...

I too buy some of my fire wood by the tri-axle load. My favorite logger friend brings his tri axle with a knuckleboom and unloads log length pieces of hardwood, mostly oak and hickory, right beside my shed. A load will usually split and stack up to about 4.5 to 5 chords 128 cubic ft/chord...

Amen that... couldn't function without my sheds...

here's mine: http://www.arboristsite.com/showthread.php?p=1927043#post1927043 several on that thread.... but the winner is: ...... http://www.arboristsite.com/showthread.php?p=1927588#post1927588

Stihl 036 pro Stihl 036 pro IPL, and service manual if possible Thanks in advance...

plate exchanger here is a sample pic of a plate exchanger. (not completely hooked up in this photo I pulled off of the web) Mine is heated via OWB and my water heater is 80 gal. I have a mixing valve set 122 deg F. During heating season while the OWB is going, I simply turn the breaker off...

See if the dealer will let you watch him do a compression test and press/vac test... He will at least have to loosen the muffler to install some rubber so to seal it off before doing the press/vac test. Ask him to completely remove the muffler, and then inspect the piston...

no welder either I'm not much of a welder either... my buddy did the welding for me... you should be able to find a fab shop or neighbor with a welder and get one fabbed up cheaper than we could build one and ship it... Whoever does the welding for you will need your splitter to weld the...