Search results

hey thanks for the help but i found out the problem, there was saw chips in the inlet screen which caused it to not run properly

i have a husqvarna 40. it runs fine at full throttle, idle, but it bogs down and will die once you start cutting with it. does anyone know what the problem might be?

alrighty thanks, ill tell ya how it goes if it goes at all.

i did what you suggested. i looked over fuel lines and they were fine, the saw has been sitting from late spring till the up untill a few days ago and now it will not start.

there is no impulse line. the line goes strait to the carb.

hey thanks, ill try that. oh and i forgot to say that i put a new carb kit and cleaned it out after it was having problems

i have a husqvarna 65L. it ran fine for about a year and then it started to have problems. at first it would idle fine but when i would rev it up to full throttle it would bog down and practically die. then i adjusted the highspeed jet and now it wont idle and will bog down and die when its at...