Search results

Looking for a pull starter housing or a complete pull starter for a Echo 650 evl . Also would like to find the rubber isolation bushing near the handle .

Looking for a set of engine cases for a Jred 910

Thank you both for your replies . Yes the top ends are nos . Thank you Sugarbush for the specs.

Hello , Does any one know the specs on the crankcase seals for a Dolmar 143 . I recently purchased to 2 cylinder and piston kits for 143's . I got them from Germany for under $ 80 apiece . I want to replace the crank seal as part of the rebuild and would prefer to use new and not NOS seals . I...

Located between the low and high speed adjustment screws is a diaphragm chamber drain screw . Are these available anywhere . Is the anything special about this plug or will any small brass plug work .

Interested in the 910 carcass . Please let me know $ and shipping to 46574

Thank you that narrows my search .

can anyone tell me if the crank cases for a jred 910 and 920 0r 930 interchange . How about from a jred 80 ?

Is the cylinder on a Stihl MS 251 coated ? It does not appear to have a steel liner . The neighbor asked me to repair his MS 251 , the piston is scored . The cylinder has some very minor deposits from the piston . What would be the best way to clean them up . I did not want to use muratic...

Is the P&C the same for a MS 251 and a MS 250 ?

Can any one tell me if the pistons are the same for a Jred 910 and a 90 . I believe the 910 piston came in 2 different ring thickness . Thanks Tom

Hello , I picked up a Dolmar 343 to use as a parts saw for a 143 rebuild . The 343 was not supposed to have spark and needed an ign module . The saw has spark but will not start , I read that if the module is bad it can have spark but the timing would be wrong . Yes = No ...

I found a site that rebuilds ignition moduals for Dolmar chainsaws . CH ignitions the gentlemens name is Adrian Ciulei . Most of what he does is for the model RC aircraft hobby . I know that the units are getting far to find ...

Hello , Looking for a piston and ring set for a Jonsered 910 . I believe it is a 54mm bore . Is an after market available or does anyone know of an oem part . Thanks Tom

blending Hello , My uncle worked for the Standard Oil Company in the blending house . They would blend oil to a specification standard . The same oil would be bottled for almost all the major brand names . All the same oil just different containers . Now there are different manufacturing...

019t ipl Does anyone have a ipl for a Stihl 019t .

Is the oil pump replacable on a Stihl 019T ? If it is how do you get it out of the case ?

Thanks , I will switch the muffler from my 112 to the 120 to get it running . The 120 needed a piston and the cly cleaned up but looks almost like a new saw . I have seen some 120 super muffler but prefered not to use one because of the louvers . I may have to mod one . Thanks for the help ...

Does anyone know if a the muffler for a Dolmar 123 will fit on a 120SI ? Chainsawr.com has one . I recently picked up a 120Si but need a muffler for it . Thanks Tom

Dolmar 120SI muffler Hello , I am looking for a used muffler for a 120si . Thanks Tom