Search results

Mine is a WT426A. Do you all think the elbow is the same?

My fuel inlet neck is cracked. The plastic part that slides over the brass part (see photos). I don’t know what to order to fix it. It’s sucking air and leaning out. Any recommendations? Parts book doesn’t seem to show that inlet neck.

Needing an IPL for a TS420 if anyone has one. Thanks fellas.

I don't think it is the choke lever part. Take a look at this photo of the air filter.

Starter pawl was on the machine. I will check the other two tomorrow evening.

I did the same thing before posting. This has me stumped

I don't think it is because I never took the handle apart

I found this part on the bench after working on a stihl 038. Any ideas on what it is? I know it came from this saw because it has a 1119 on it.

The bottom bucking spike hole into the case of my 046 stripped out. I did not realize it until the screw was gone and the bucking spike plate was loose. When I got the new 5mm screw, and tried to replace it, I noticed the hole was stripped. My question is, should I helicoil the hole back to...

Trying to get the parts book and service manual for a stihl fs76 trimmer.

What's is your opinion on that paint coming off on the inside of e crankcase? Does it even matter?

First off, I would like to thank everyone for all the input and help. You all made me want to look closer and I noticed this, the finish inside the crankcase has been flaking. I have attached additional photos for more ideas. I have definitely rulled out the straight gas. I have had this...

Some more information. The saw was completely rebuilt one year prior, with all genuine Stihl parts at the Stihl dealer (new piston, cylinder, and carb kit). He ran it for about one year until this happened. Said he was in a log when it lost power and died. Said it would not restart. I know...

You thinking too much ethanol?

Best I could tell it was part of the piston. It seemed to be aluminum.

I wish it would. Hard to see in the photo, but the cylinder has significant grooving on the exhaust side. No hope for it.

Guys, I was wondering if I could get some help. I have looked this thing over and at first I figured it was just a typical lean issue, but then I checked Madsen's piston failure pictures and it looks like the detonation photos. This saw belongs to a friend and I and rebuilding it for him to...

I am trying to locate a service manual for Stihl 028. Thank you!

I guess I will try and mess with it more in the next few days. Sure is frustrating.