Search results

Found the problem. I was trying to use a cover with the plastic chain guides. Oil was flowing right through the side of the bar oiling hole, and then out the other and into the casting channels of the cover. I dug out another cover with a metal outer guid plate....... just doesnt have the...

lol, WOW

Anybody ?

Hey all, Over the past week Ive been working on putting a few saws together to make one AWESOME saw.... at least in my eyes...lol. Heres the rundown, 026 PRO crankcase, crank and oiler 024 piston and jug Just got everything together today after work and figured it would be a good...

one in the morning working on your truck...and a saw at the same time ? Got a lot of energy to burn ? Throw a rubix cube in and youve got a party.

The dollar is slipping...thats all. Less buying power of the US dollar...... Gas prices rose recently....... gas prices per barrell did not. That points to the fact the US dollar.....is fading fast.

Hmmm, neat. Never seen this before.

I must had too many Blue ribbon's the other day when I tested that carb after I cleaned it. Got my kit in today, go to the shop to proceed with the rebuild..... first place I start is at the needles. Thats where I found it. Both, screwed in all the way. Ha ! Just for giggles I run em out 1...

Over by Owensboro in a town called Henderson. Just south of evansville Indiana and 45 or so miles East of the Illinios line.

Thanks gentlemen, I have a kit on the way ! Two 024's have to be better than one right ?...lol

Any preference from the guys who are in the know between the two ?

Been looking around....wonder if it just be better to get a walboro to slap on it. They seem to be a more common carb for parts. Am I correct in assuming this ?

Long time lurker..... first time poster. Ive had a 024 Super (I think, it says AVS ?) for quite a long time, its been a good saw.....I cant complain. While searching Fle-bay the other day I noticed a 024AV....said it might have an air leak. Bid and won for 88 bucks. Its a VERY clean saw...