Search results

I dont need the whole shebang. A complete or mostly there 3120 will do.

Builder or complete, have cash, saws, parts etc. Thanks

Had 2 tanks of tru fuel ran through it to fell a big maple Bark box West coast dogs Hd air filter 36" tsumara light and tough 6 neotech chisel chains 5 new 1 used 36" stihl bar cover. $1375 Shipped tyd lower 48. Paypal f&f preferred. Money order or check when it clears

Red-kote works very well as a sealer. I use an old paint shaker. I clamp the case with the tank fuel of bb's and solvent. Let it shake for 15 or 20 minutes. Than drain it and clean again with acetone a couple time. Than seal with that red-kote. Works very well

I know all too well the ebay flippers. I had a gentleman give me a sob story on his grandfathers 910 that no longer runs. Needed an ignition. Well I felt bad for him and decided to sell him a nos ignition I had. The coil over plug hard to find ignition. Well....3 or so weeks later there it...

Looks like an 801 to me martin. Same top cover etc as a 90.

Pm me any time. Run and have a pile of jonsereds

I have a real nice low hour 55 air injection that I would sell so you can put it on and do your thing. Has new impulse pipe and intake boot. Carb mount is in great shape. Pm me. Priced reasonably

One and a half turns out each one and adjust as necessary

My biggest worry would be how hot he has gotten that saw. I hope he used good oil or else you may have bigger issues down the road. Other than that less fins equal lighter saw..lol

Yes I bought 50 gallons @4.99 a gallon on sale.

Your safe in the ultrasonic with the cylinder.

SOLD

100% complete. Piston looks great Starts and runs, oils fine. Has a replaced starter spring. Has some surge etc...probably needs a crank seal or two. Any 15×30×7 double lipped crank seal will work. Someone I believe used carb cleaner to clean air box at some point so paint is not perfect and...

I have clutch covers for 910 just no brakes. Sorry

Texted ya!

No offense but I have probably 25 49sp complete let alone parts saws and nos parts. I didn't get their buying saws according to ebay

Pm me on that 111s full wrap.

I would show you the full saw but it's apart getting some loving. This is the only one I've ever found. And yes most of those mounts on a 910 or even these, I only have ever had one example and that was toast.

Yes. It doesn't come up on any 80/801/90 ipl. We don't need to worry about finding them....😉