Search results

-29 this morning and got the Heat Pro burning.

Check out Drolet, I have the Heat Pro

Yes I thought the same, it was close to 20 above here. Once the fan kicks on the chimney cools a lot. Even when the furnace is burning hard the flue temp goes down. I guess I'll use poplar for warmer days.

Today I had my garage fill with smoke, I had the stamper door shut on my heat pro furnace. The only thing I can think is that I either had a back draft or I lost draft in the chimney causing the stove to release the smoke though the air intake vent. I open the draft door and the smoke inside the...

-24 here in NW Minnesota, been below zero for quiet a few days now. Nice November but December is cold, Drolet Heat Pro keeps up nicely,

Yes it's hard to get the draft going at that temp. I use small cuts.

I use both saw and axe. When I'm not in a hurry I will use an axe. Just something about using an axe.

Get a heat pro from SBI/Drolet

Hoping people will learn or least recall some of these safety measures.

What do you think or know cause wood stove fires and have you ever had one?

-14 in northern mn

Burning hybred poplar now. It's 2 years old split. Have oak and it is 4 and it burns good.

Thanks for the information.

I have the Drolet Heat Pro and according to the book it takes 460 watts to run the fan. Now I'm not a math wiz so if the fan ran over the course of 3 hours per 24 hours at a cost of .11 cent per kilowatt hour what does it cost to run?

Not sure why, I'll get it to work, if not I'll call them and get a replacement. Their customer service is good.

I checked it by drilling a hole dead center of the top of the pletium when the furnace was hot. The temp inside the pletium was around 150 degrees. Now the fan will kick on soon at a lower speed so I just waited till I had 150. I had trouble with My draft door opening but spoke to sbi and was...

Well I don't know what your area temps are, you can build a smaller fire in the Tundra and the heat pro. Nice about the heat pro I can build a larger fire cause it will get cold here soon. As far as which to own if you have the space go with the heat pro and adjust your fire to current temps...

Here is a pic of mine

flotek, mine closes fine it is that it sticks when it is suppose to open. Have to look at it today.

Spoke to SBI, they said the switch on the back is just to read, cant change the temp on fan, that is locked on the card. Had mine going and it is nice. Now the probe runs the fan. Fan does adjust, WC is at . 2. My air flap keeps getting stuck closed but hoping to take care of it tm. Must be...