Search results

I have been re-working my splitter over the last year and I was wondering about the valve I bought. It was listed as a 25 gpm valve with 1/2 work ports and 3/4 in/out ports. I also read in an earlier post that when you go to a 22 gpm pump you need to go to 3/4 lines. is the valve going to build...

Hi. I have an 11hp Honda engine that I want to use for my splitter that I bought last year. It currently has a verticly mounted Briggs engine with a belt driven pump. It blew a seal after I finally got it working and I want to use the horizontal shaft Honda to power it. My question is. When...

Hi, i need some help identifying this log splitter i just bought it off craigslist. it needs a hose and some carb work,but, i think it will make a nice splitter. the guy i bought it off of said he thinks it is a 25 ton. i see some writing on the side but it is falling off along with the paint...

I have had my stihl ms250 for about 10 years, bought it new. it started over-revving one day and I figured the impulse line, the intake boot, or the fuel line had rotted a hole in it. It has never missed beat until this fall, and when I took it apart to fix/look at the rubbers I noticed the...

I have never drained/ran dry the mix in any of my saws, I just ran them some during the dormant months and i have not come into any problems with stale gas or deteriorating rubber. But since i have aquired CAD, I have more than a few to maintain and I would like some opinions on how to store my...

Hi, is it possible to change the plug wire on an electric ignition coil without having to change the whole coil. Thanks Nick.

Vintage Poulan 245 Super Automatic P60 Super 66 090 s-72 92 066 | eBay I bought this yesterday and was wondering if the rings are the same size as the 245 and 245a I looked at acresinternet and the displacement varied a little. I hope it will make a good big brother to my 306a Thanks, Nick.

What can I use to make a muffler to cylinder gasket (or plate) I am too cheap to buy one. Thanks, Nick.

I have been working on a Stihl ms 360 that I got from my brother's landscaping company. It had a nasty piston and cylinder so I ordered one on ebay and put it on, along with some other items and then I installed it and ran it a little to break it in. It seemed to have a hard time coming up off...

I just put a new jug and piston on my newly boought 360 and wanted to start it up but, It has no clutch bearing. If I take off the sprocket is it safe to idle the saw or should I wait till the bearing comes in? Also what is the proper break in procedure for a new top end? this is my first...

I have a poulan 306A and I need the gasket that goes between the tank/handle assembly. Does anyone know what I could use to make this myself? The gasket (what was left of it) is spongy and like 1/4 or5/16 thick it seems to need the thickness to fill the gap around the carb throat. I cant find...

My dad has an older Sears Craftsman chainsaw, it is 3.3 cubic inches and the model number says 358.356332. I am looking for a replacement bar and chain for it. The bar that is currently on it is 200PXBK041 PZ. I dont know if this is the right bar for the saw. Any help would be great. Thanks, Nick