Search results

Sounds like it’s going lean when it warms up. I had a saw that did this. Maybe loose muffler, bad gasket from carb to jug, bad jug gasket, bad crank seal? I sure there’re other possible causes. Mine was a combination of a few things. Be careful and don’t let it get too hot; it’s easy to...

Ahh that makes a lot more sense. I don't know how the thing came off though. I hadn't ever taken that pin out. Oh well. I will put it together now and go :chainsawguy:. Thanks everyone. Jordan

bump to the top

Hmm - having a hard time with this throttle cable. Somehow it came completely off the trigger in the handle during a fuel line replacement. I can't tell from a parts diagram how the loop end is attached in the handle. The only thing I can guess is that the long spring goes inside the loop and...

I'm having a little trouble with this tank vent leaking when filling up the saw on it's side. It is actually a 120SI handle and vent with the rest being 120 Super. The barb broke off the vent before I got it so I drilled it through and pulled a fuel hose through. It is actually leaking out of...

Where are you at in TN Hank? I am in Portland. There are about 5 maples in my neighbors yard waiting to be milled; they look a lot like yours... guess I better get to work :lifter:

CS-451vl I know this thread is old but I just finished up work on this old saw and thought I would share. It was my grandads and he wasn't one for fixing things after they broke. I found this saw and a Poulan 2000 in his garage this fall. Neither was in running condition but both needed very...

I have a Sachs Dolmar 120 Super that I am working on. It originally had a primer bulb on the tank handle but was long gone since I have had it. It has had a bolt, nut, and an o ring in its place. I have a 120SI handle that I want to put on it but have questions about the primer bulb operation...

I have a used Sachs Dolmar 120 47mm cylinder and piston, wrist pin, clips, and jug bolts in very good condition. It will need at a set of rings to get going. No scoring in cylinder. Piston can be reused. I am looking for a handle assembly and a chain brake band for a Dolmar 120 Super and a...

just a friendly bump to the top :clap:

The bore measures 47mm or 1.850". Is this a regular model 120 cylinder? Will it fit other models? Thanks! Jordan

Anyone out there have a good cylinder and piston for a 120 Super? I hate to sink $205 into an old saw even though I love it! Thanks for the help! Jordan

I guess the brake handle. It's not the sprocket cover. Thanks!

I have tried to find another guard that attaches to the chain brake on my 120 Super but to no avail. Does anyone have any suggestions on who I could talk to about a replacement? I thought about just making one out of aluminum but I have been pressed for time lately. Thanks! Jordan