Search results

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. P

    The Beg for Manuals Thread

    Thank You Very Much My Good Man!!!!:cheers:
  2. P

    The Beg for Manuals Thread

    Anyone out there have a shop manual for a Stihl 041AV in pdf? Your help would be greatly appreciated. Thanks, picklenjim! [email protected]
  3. P

    Stihl 028 AV Super... is it worth fixing?

    If your going to use muratic acid use as little as possible and be ready to flush it with water. Try just using it on a Q-tip if possible or wrap a small wad of cotton on a chop stick and wipe it around. You don't want it on the chromed cylinder wall any longer than necessary. Remember to flush...
  4. P

    Stihl 041 handle question

    Been following 041's on ebay and parts saws not running with no bar are going for around $100 with shipping. A running 041 with bar and chain are getting $200+ with shipping. Duncan, Is this what your looking for? STIHL CHAINSAW PARTS 041 FB REAR HANDLE 1 1110 084 0901 | eBay
  5. P

    Stihl 028 AV Super... is it worth fixing?

    I seen on ebay they have pistons for $28 and cylinder and piston kits for about $150. Their 46mm. Just go to ebay and search "028 super". There's about anything you might need.
  6. P

    Stihl 041 clutch assembly torque

    Couple questions here on torque when assembling the clutch on an 041 that I'm restoring. 1. The center part which seperates the weights threads down on the crank. How tight do you tighten it against the inner washer? 2. How tight do you tighten the outter nut against the outter washer? Thanks!
  7. P

    Stihl 041, points or electronic

    A problem I seem to see regularly is the kill swith wire. The insulation hardens and then breaks off in large pieces. That would be the first thing to check out. You can cut the plug off the switch end leaving about an inch of wire on the plug and slip heat shrink over the rest of the wire. Then...
  8. P

    Stihl 041, points or electronic

    If anyone needs parts for their 041 check out ebay. Just go to ebay and search "stihl 041". About any part you need there.
  9. P

    Stihl 041, points or electronic

    I was going by the method shown on pages 44 & 45 of the zip file in post 21. That's the ignition I have. I have 2 of these and neither have marks on the case but they do on the flywheel. I don't see any reason why I can't make the mark on the case myself though. I saw in one place where they...
  10. P

    Stihl 041, points or electronic

    Hey thanks cajun! What I was saying in reference to the clutch is acording to the instructions on setting the timimg in the zip file page 44 in post 21, with the piston set at 2.5mm btdc and the alighment tool in place you make a mark on the clutch for shooting your timing light at. I don't have...
  11. P

    Stihl 041, points or electronic

    Newbe here with a question on timing an 041AV with electronic ignition. I'm going to make a pointer that mounts on the bar mounting studs simular to the one in the attached pic Lakeside53 has back in post 21. My question is, is the point of the pointer exactly on a line running straight through...
Back
Top