Search results

No do they need to be removed Thanks

Just picked up a 338 xpt not running, cleaned it up replaced the primer bulb. Saw will start idle but acts like it is starved for fuel if you throttle it up. I would like to rebuild the carb with a carb kit but since this is a california model it seems to have a different carb than the standard...

Looking for a repair manoul for husqvarna 338xpt california Thanks

Begging for ms201 manual and ipl, ms441 manual and ipl Thanks

In need of a ms390 service manual. Thanks

I need the service and parts manual for a ms362 please Thanks for the help

Thanks for the help and quick reply

Anyone know the identity of this chain. I was gifted a partial roll of this, it appears to be .325 .050 chain. Here is a picture of the chain and spool Thanks

The table top came from same load of wood, milled it about 2 mos ago. Wood was fairly dry , I am not sure of the moisture content as I dont have a meter. Log base was from some 2 year old logs we going to split for firewood. Thanks

Here are a couple of pictures of the first 2 logs we milled and a log table we made from them

So split it between the forks like quartersawing it. And then slab the 2 pieces? Logs were given to me, the other logs I have cut from this tree have some nice spalting in them as well. Thanks for the advice

I need help with this large pecan log Log is about 34" thick at the base I have milled slabs from 30" logs before using an alaskan 36" mill and 394xp Any recommendations on how to best mill this log Thanks

Any thought on the NWP kit From Baileys The regular 044 kit is 89.99 and the abig bore kit is 99.00 Thanks for the advice

Deep gouges on the intake side, rings were intact, must have injested something Heavy scoring on the exhaust side as well

I have a stihl 044 that needs a total rebuild. Piston and cylinder are shot, needs new bearings and seals Gas and impulse lines I need advice on decent PC kits, it is a later model with 12mm See a lot of big bore kits online, always wanted a 46 or 460 thought this might be an alternative Thanks

Maybe since he has 2 of them 2 stihl 70 chainsaws

Stihl 070 says its new stihl chainsaws

The bar was clogged as well, had to remove the bar and chain and clean the chain groove on the bar. Never had this issue on any other saws I own.

I noticed the same condition cutting some cedar this afternoon, chips are not being cleared from the chain sprocket. The ridge you mentioned seems to be keeping the chips from clearing the saw. Mine clogged to the point I thought the chain brake was on. Any pics of your mod to the cover

No personel experience with the Cs600, I was just compairing the specs. Sorry for the mis quote on the horsepower rating for the MS311.