Search results

just got this for shop had a 461 come with a blown out spark plug. i have the 10mm kits too and love it. that sav a thread insert dont seem as good and they used to be...

Got a toro 3000 series in shop. Battery going dead in about 2 days. I think I traced the parasitic draw to the hour meter/ interlock module anyone ran into this before?

new limiter cap tool for echo cs-4510. Does anyone know when saw will be available in us?

i need a set of good heads for a kohler ch23s

got a Briggs twin intek that takes several Sec to throttle up to 3600 top noload has any had this problem before? Also there is two slots in gov arm that gov spring can go in, it was in bottom hole when I pulled engine to replace sump. Another engine at shop has it in top hole same engines. I...

need a set of good used heads for kohler ch23

just got this for 45.00.

want to buy a 660 cylinder. Am ok

want to but a jonsered 2252 piston. use ok as long as it has the machine markings

need fs 86 throttle trigger and its return spring. if anyone has one in the junk pile send me a pm and i ll send you the pic of the trigger, as they made several diff ones. i dont have the trigger return spring. i think the return spring is them same on all of them.

is there any appliances tech on as. if so could send me a pm. need a service manual for a model-j bp35dm1bb ser-mr2680210 thanks this is for my own oven

i have a kaw 721v in shop that acts as if there is not a gov on it. will idle perfect and it hits 3600 top no load and then all of a sudden revs like a indy car. all gov parts have been replaced and everthing is set to the service manual this thing has me shaking my head. carb has been rebuilt...

need a oil pump for a poulan saw see pic. can buy, trade. i have ton of parts just never the one i need lol

any great dane dealers on here if so send me a pm. need some parts and info

if there is any robin dealers or someone that can get robin parts can you send me a pm

whats do y'all think about porting a homelite 1050. I have two and was thinking I having one ported.just wanted some of your guys wisdom.

just found a new tool to take off flywheel and clutches. http://www.ebay.com/itm/USED-STIHL-GAS-POWERED-IMPACT-WRENCH-/172300120130?hash=item281de33042:g:iD4AAOSwMNxXUI37

any John Deere techs or anyone that has worked on a lot of John Deere Efi mowers will u please send me a pm

frist come first served. you pay shipping. ill even buy parts if not too much. just bought a mgd1 tester that was used and what to make sure it works

can you send me a pm got a question for ya tia