395

Has anyone used a 592 xp for milling consistently? I have a beautfiul 395 xp I bought a couple years ago and mill 10 logs per year or so, but love the look of the new 592 and the idea of Autotune. All of my other saws are M-tronic or Autotune. I would probably make about $300 selling my 395 if I...

I'm a bit torn as to sell or not to sell my 394xp. It's in good condition, all oem parts and runs good. I have someone willing to buy it at 900$ CAD. It has the full wrap Here are some pics: I put it up for sale because I am in need of the money and I don't use it that much (maybe a...

AV spring system complete with screws if possible OEM only. Also looking for another 394 top cover busted or not to chop up. 394 air deflector behind the muffler. Or 3120 type 394 flywheel Flywheel dogs, springs and bolts. I have OEM air filter...

I am just finishing a rebuild on a 395xp and have some concerns about the flywheel side crank seal. I haven't been able to locate a service manual for the 395, but have a manual for the 394. It says to recess the seal 5mm from the outer machined edge of the case. This seems rather deep. Does...

Hey guys- I'm looking for a Husqvarna 395 flywheel and two 20" large-mount Husqvarna bars in .050" gauge x 3/8ths pitch. I got cash and trade. Thanks!

Looking for a flywheel for a project 395xp. Can anyone help a guy out?

Hey guys and gals, I'm looking for a bigger saw for falling larger trees, bucking, and milling. 80cc and up, or something 70cc+ that's modded Stihl, Husky, or McColluch would be preferred. I'm happy with older saws, so long as they are in good condition! My budget is $500, bar included would...

Hi Guys- I'm chasing a nice clutch side (PTO) crankcase half for 394/395 or a whole crankcase. I bought one off ebay but it turned out to have a wallowed out bearing pocket on the PTO side, which happens a lot when people run long bars and keep their chain too tight. I have cash or lots to...

**Trade Pending** Thanks Hello, here's a few pics of the saw.. I did do a muffler mod last weekend and haven't gotten pics of that yet. I can grab some, no problem. I'd like to trade for an 066 or m660, 394, 395, maybe Dolmar, Makita, etc.... Consider anything but I'm trying to avoid...

Front of piston was all scarred up, rings fried, rear of piston and cyl fine. Almost seems the cyl wasn't straight? Definitely pointing forward. $150 down the drain.

I'm pretty new here, but I've been watching the threads for a while now to try and buy a large milling saw to replace my makita 6401 with BBK that the dealer says needs new bearings now, but haven't found the right one in my price range (those 6401's can be quite the deal). I'm looking for...

I'm trying to locate a 2095 muffler and haven't had any luck yet. Do any of you guys know where I can get a muffler for this saw? It's gotta be in good condition ie no cracks.

Selling my near new condition Husky 395XP. Very low hrs of use. I purchased this saw years ago for a job and it has hardly been used. I fire it up occasionally to keep it fresh. Always use quality fuel and oil. Always drained after use, never stored with gas in the tank. Meticulously maintained...

1603 Just got this crank case off eBay. It's a 394, smooth spinning and no play in the bearings. Since the 394 carbs are a lot cheaper, and I need everything from nose to fart box on this thing, I'm thinking about getting a 394 carb and the conversion kit, as the kit comes with all the linkage...