bucket truck

🌳 Elevate Your Career with Marv's Tree Service! 🌳 Are you a seasoned Aerial Lift Operator/Tree Trimmer seeking an exhilarating work experience to take your career to new heights? Look no further! At Marv's Tree Service, it's not just a job; it's an adventure in the world of cutting-edge tree...

1986 aerial lift of Connecticut boom 55 ft mounted to ford truck with Detroit diesel. Under cdl runs and drives, boom operates properly. Truck needs work to pass inspection. Will sell as a complete unit or will part out the boom and truck. Best offer, price negotiable located in Western...

Looking for feature suggestions as well as general insights into increasing efficiency specifically in the task of lifts and removals. Like every other tree company, I encounter a lot of EAB removals where climbing is either out of the questions or limited. This often mean working from a lift...

What height bucket truck would be the tallest you can buy? I have a 55’ working height forestry truck at the moment, but it too small for most trees that I encounter. I had thought a 75’ forestry truck would be ideal, but I have seen that they make over-center buckets trucks that extend up to...

Couple of Bucket maintenance / operation questions: 1: The dump bed on our truck has body stays for use when conducting maintenance while the bed is elevated and could cause injury/death should a cylinder fail. These seem like good things to always use and I do. Our bucket has an elevator with...

Thinking about buying this as my first bucket truck. The guy originally told me it's a 65' but he was wrong. It's 48 platform height and 32 reach. Is this truck too small? $8500 is the price and it's been garage kept. Low miles and runs great. Needs a couple of tires and misc..

So I’m looking at a few bucket trucks. They are davey tree trucks. Most of them have the lrv-55 boom. On the hour meters I’m seeing 3900 or 1600 (06 f750). There is only enough for four digits on the hour meters. So my question is... is this probably 11600 hours and 13900 hours on it?

Hi All, I purchased a '99 Freightliner truck with a 55' Holan bucket. The truck has been well serviced and cared for by a large electrical contractor, it has a joystick and three extras hydraulically actuated jib, winch and bucket tilt. I'm running into an issue with the controls for the three...

It's time I make the leap. I am looking for a dump truck and chipper of reasonable price and working condition. Bucket/chip combos are a possibility. If you have equipment to sell, send me the information with pictures and we can go from there. Thank you in advance for your responses!

It's unclear whether the man was harnessed to the bucket or not. Story as of 5:40pm on 2/27/2017: "A Johnston County tree trimmer was killed when he was thrown from a bucket truck Monday morning. Family members said Kenneth Earl Vick, 65, was working with his brother at a home at 402 Dixie...

Would any have or know where I could find hydraulics diagram for an LN-50 boom. Chippies ate some of my control lines. Bought new line and replaced them all while I had it down. Now I have no control at the bucket. I must have miss something. Thank you,

2001 International 4700 (VIN#1HTSCAAPX1H361128) w/ Terex Hi-Ranger XT-5 (Ser#2000512896) 60'working height break over center; forestry body w/ chip dump box and tool boxes; hydraulic brakes and steering. $29000, 850-508-2682