husqvarna 350

Hello all , Andrew from OZ here , have always looked at this site and gotten great advice , just wondering if anyone has seen this before …… Got a husky 350 in with a pile of other saws , some I fix and keep , some get sold on I have several saws but nothing around 50cc and thought I’d look at...

Husqvarna 350 has brand new 353 piston in it meteor brand complete saw i dont think i got it started because of carburetor but honestly i cant remember been siting for couple years 180$ plus shipping . Pho

Couple of boxes arrived in the mail today, new fixer uppers- although at first glance there appears to be very little to fix! Jonsered 2137 (I know, I know- the little Jonny everyone loves to hate Red Poulan, Red Wildthing bla bla bla) and a Husqvarna 350. The 350 came with the GB Pro bar...

Hello my friends! i bought a husqvarna 350, it's a pre epa, no primer bulb, walbro carb, plastic intake clamp and it has the less desirable 44mm p/c. 1. Is the carb upgrade to zama a straight bolt on, or do i need to change something else. 2. If i delete the base gasget and do a muffler mod...

I picked up a cheap locked up Husky 350 to rebuild. I figured it would be smart to go ahead and replace the seals while I have it torn apart. Does anyone know of any decent aftermarket seals? I haven't had much luck finding OEM ones. Thank you!

Hi all, first real contribution here (if you could even call it that). It's not much but you may get at least a good chuckle. As I couldn't find any existing thread on the subject, figured I'd start a new one. One of the rubber bumpers on my 1998 350 that I'm rebuilding got beat to pieces...

Well I have owned a 06 husqvarna 350 since new started with a MM. Then watched a few videos Matto and hill top saw shop. The husky has always ran good most times I would leave my stihl 029 super at home. Also bought new. Went to a pawn shop around the corner there was a jonesred 2150 it...

Hi. 350 was running when put away about 2 years ago. Now won't start/run. Replaced with OEM ignition module, new plug, cleaned carb (actually it was very clean when I disassembled it). After multiple no start, I pulled the mixture screw limiters and started at 1 turn on both hi and low...