mod

Hey guys, I'm wanting to put a side exhaust port on my 372 muffler instead of the top port... tired of it burning my hand when I've got the bar buried bucking big logs. What size should the exhaust port be? Not really looking to get max power, but a performance boost would not be unwelcome...

I have an 076 chainsaw, been thinking for a while now it'd be so much better with a ts760 air filter and cover (same frame/chassis). Basically the cut off saw ts760 has a raised filter cover and decent paper filter with outer and inner pre and post filters, that's a three stage filter before it...

I smoked my cylinder on my 660 clone while milling by having the high adjustment too lean. Now I am holding a new 36$ knock off cylinder in my hand and have just ordered a degree wheel to check timing. By just measunring with the calipers I can tell that this cylinder is way off compared to the...

Hi all at AS. Can a 36 pump be modded to pump more oil? E.g. enlarge oil holes and file a bigger flat on piston. Saw oils but seems stingey. And yes every thing clean,bar groove and oil hole good no blockages. Breather good. Cheers Chris.

Needed a muffler for a Jonsered 2152 build and found this one on Ebay from a US seller for $13 shipped. This was almost too easy didn't even have to light my torch. It's just an empty can with a 1/2" i.d. pipe, just what the doctor ordered. These fit most of the Husqvarna and Jonsered 45~52cc...

How does M-tronic's affect porting/modding, AND How does porting/modding affect M-tronic's?? #1.) If the muffler is the only thing modded? #2.) If the only thing done was removing catheters? #3.) If the carb is the only thing modded? #4.) If the whole sha-Bang is ported?