starting

Hello! I'm new to the forum, and hope Im not repeat posting by asking this. I work on a summer trail and fire crew. We have our wildland fire red cards as well as an S212 wildland fire chainsaw certification. We drop large dead Doug firs and other large pines trees during the summer as well as...

I'm a climber and owner of Blake's Tree Service. I've finally saved up 24k cash and want to throw it on a chipper. I have a 2012 6.7L f250 and a 14k brand new dump trailer. Is it practical to chip into a dump trailer, requiring me to involve another truck to haul it? Let me know your thoughts on...

Hi group, I'm a complete newbie, and I ran a brand new echo 590 for a few minutes with the brake on. Of course it started to smoke but I was under the impression it was the pre-mix. The wind changed and I smelled burning rubber... I was trying to get the brake off before starting it but I...

Just ported, deleted base gasket, and MM'd my Dolmar 460. Inlet and exhaust ports were widened side to side but not raised or lowered and intake ports were flowed but not enlarged. Power gains at WOT in wood are great its just been finicky on start up, revving and while idling. It 4-strokes...

So whenever I start my Remington Outlaw (46 cc, 20" bar) chainsaw for the first time that day the chain spins super fast, like full speed and continues to run at full speed until I press the throttle. I tried to use the chain brake for this simply because I didn't like it spinning so fast...

Hey Fellers, I go by axe, I’m 27, I’ve been doing tree work since I was 18. I started dragging brush and humping logs for the first 2 years. Then taught myself to climb from untying my bosses knots. Long story short I still use simple monkey knot, running bowline, and Clove hutch. One rope...

So I started a thread many moons ago about this saw. Got it with a scored piston, tore it down and put in new seals, meteor piston, spark plug, fuel line, fuel filter and new gaskets. I have not vac/pressure tested it, I know I know... Figured I would try starting it without rebuilding the carb...