• If you have bought, sold or gained information from our Classifieds, please donate to Arborsist Site and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Sold 2016 372 x-torq

  • Thread starter Deleted member 117362
  • Start date
Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
D

Deleted member 117362

Guest
2016 HUSQVARNA 372 x-torq. Just finished case up rebuild. Aftermarket parts are clutch cover and felling dogs. SKF 6202c3 case bearings. New oem parts gaskets, seals, clutch bearing, hand guard, coil wire,o-ring, rewind spool and spring. Muffler was opened up under stock screen. Only muffler was painted, cases were not. Top cover and rewind covers are scratched, but no cracks. Motoseal was used on case and base gaskets. Blue thread locker was applied to muffler, case, oil pump and cylinder bolts. Cylinder and piston came from a J-red 2166 take off (purchased from Dan on parts thread), removed baffles from transfer covers, turning it into a 372 x-torq p/c. Saw runs nice. Paypal F&F $400 plus shipping UPS. Almost forgot, my camera takes better than actual pictures, so I have been told.
 

Attachments

  • IMG_8663.JPG
    IMG_8663.JPG
    2.2 MB · Views: 99
  • IMG_8664.JPG
    IMG_8664.JPG
    1.4 MB · Views: 92
  • IMG_8665.JPG
    IMG_8665.JPG
    2 MB · Views: 91
  • IMG_8666.JPG
    IMG_8666.JPG
    2.1 MB · Views: 88
  • IMG_20191203_150709053.jpg
    IMG_20191203_150709053.jpg
    626.8 KB · Views: 87
  • IMG_20191203_074459490.jpg
    IMG_20191203_074459490.jpg
    564.4 KB · Views: 87
I rebuilt a 394xp for local tree service he had given me about 4 years ago. After rebuild he wanted it back, good friend, so it went back. Have seen them sitting around, most are beat up bad.
Beat up bad is what I want. I'm gonna throw new wear parts at it top to bottom and run it hard on a Granberg when I use it.
 
Back
Top