Sold 357xp $250!!!!!

[FLchainsawJoe]

*Posting again since I can longer edit titles* 2011 model runs strong but tends to stop if idling too long. Probably the nature of the carb that came on these saws as one member pointed out. Could use tuneup which price reflects. Has a small piece missing of housing near choke. $300 obo plus shipping. Paypal f&f please.

 

[sunfish]

Little rough, but a damn good model!

 

[FLchainsawJoe]

edited previous...

 

[FLchainsawJoe]

No takers?

 

[cuinrearview]

Have you done a compression test?

 

[FLchainsawJoe]

Have you done a compression test?

Not yet. Good point. I’ll get a measurement a little later.

 

[FLchainsawJoe]

Compression is right around 145 psi.

 

[FLchainsawJoe]

Guys is this pressure decent? Does it justify the $300 asking price?

 

[cuinrearview]

PM sent

 

[sunfish]

Guys is this pressure decent? Does it justify the $300 asking price?

Should around 170 psi. & like I said, it is rough.

 

[FLchainsawJoe]

Should around 170 psi. & like I said, it is rough.

Redoing it tonight cold. Manual said to run engine for 5 mins and then do test and I feel the connection became loose with the pulling.

 

[beaglebriar]

The broken case hurts the value imo as well as the overall condition being kinda rough as sunfish stated.

 

[FLchainsawJoe]

I’ll get some better pics tonight. The chip out of case does not affect operation. Agreed it does however affect price but that why this one is cheaper than the rest of them listed on here.

 

[Josh 0619]

I just sold a small pin saw in better condition that I went through from top to bottom for $300. That said, if yours runs good and the piston looks good I don’t think you’re out of line. Post a piston picture, I have a hard time selling 357’s that’s why mine are priced how they are

 

[FLchainsawJoe]

Update: I did the compression check again and realized the decomp button was sticking a little and not completely out. Pressure reads 160psi after fixing. Included a couple better pics.

 

[sunfish]

160 is a much better reading. Like said, pull the muffler and get a picture of the piston.

 

[FLchainsawJoe]

For those of you that missed @chipper1 357xp deal. I’m taking offers on this runner!

 

[chipper1]

For those of you that missed @chipper1 357xp deal. I’m taking offers on this runner!

Let's not forget mine had an AM cylinder and wasn't running.

 

[FLchainsawJoe]

Let's not forget mine had an AM cylinder and wasn't running.

Good point Brett!

 

[cuinrearview]

Always bad to have the most or least expensive house in the neighborhood. The riff-raff has moved out Joe.