Sold 357xp

[cuinrearview]

Nice set of 359 cases and starter from Dan in Greece. All OEM crank, stuffers, seals, and Nachi bearings. Meteor piston and Caber ring. OEM jug had a screwdriver used as a piston stop. Exhaust slightly raised and widened. Intake widened and lower transfers opened up. Dual port muffler and timing advanced. Carb rebuilt with a Walbro K22 kit and a new OEM fuel line. $425 with or without the 20" Tsumura and new carlton full chisel chain. The bar has a little ding in the tip but it's cut fine for three tanks I've ran through this saw.

 

[cuinrearview]

This vid was about the eighth cut this saw made. Before I did the muffler.

 

[cuinrearview]

Here's the muffler. The video reminded me I rebuilt the clutch with new OEM springs after that too.

 

[Trent Curtis]

In for the rep- excellent seller here

 

[cuinrearview]

In for the rep- excellent seller here

Thanks Trent. I got the mesh filter from Canada for the 034 Super I finished just after this saw tonight. I have a videographer secured for some vids of this one and that in a huge maple trunk same chain tomorrow. I'm secretly pleased it didn't sell overnight because the Super is a runner and I want to run them together finally.

 

[cuinrearview]

Well, the comparo vids aren't happening. A local guy hit me up for something mid-sized this morning. He cut two cookies, shut it off, and reached for his wallet. This one just sailed out the driveway.

 

[grizz55chev]

Well, the comparo vids aren't happening. A local guy hit me up for something mid-sized this morning. He cut two cookies, shut it off, and reached for his wallet. This one just sailed out the driveway.

Party!