AUSSIE1
Al.
- Joined
- Aug 25, 2006
- Messages
- 8,004
- Reaction score
- 1,979
Do you use anything in it's place? Or are the machined surfaces precise enough to assure no leaks?
Silastic, Hylomar, 3bond etc. As thin as you can apply it as most of it will be squeezed out. Around the edge of the crank case were the cyl sits in, run your finger along wiping away some of your sealer so it keeps it away from the edge. This is so that when the barrel is pulled down it helps prevent the sealer from oozing into the crank case area.