Want to Trade 394xp parts for builder 2165

[astnmacgto]

Looking for a jonsered 2165 builder saw to trade for 394 parts i have.

I would prefer it to be mostly complete but it doesn't even have to have a good top end.

These are the 394 parts i have. They arent all in great condition but they should be effective lol.

 

[Jacob J.]

What kind of condition is your crankcase in? I just got a 2065 in last night that is good internally and actually runs.

 

[astnmacgto]

Not great, this was a saw that had a tree fall on it, and it was abused.... it could be built into a functional saw for someone who doesn't care about looks but that's where it ends I'm afraid

 

[astnmacgto]

3rd pic is showing a very small crack next to oil cap on that embossed piece

 

[marti384]

3rd pic is showing a very small crack next to oil cap on that embossed piece

Is that a common problem on those? I didn't notice my 394 was cracked there until I finished a total rebuild, then had to strip it back down and switch the case half out. Good of you to look it all over and point it out to your future buyer.

 

[astnmacgto]

Is that a common problem on those? I didn't notice my 394 was cracked there until I finished a total rebuild, then had to strip it back down and switch the case half out. Good of you to look it all over and point it out to your future buyer.

I couldn't tell you, it appears to only be a surface crack but idk.

I try to look over everything before buying or selling, I would want to know everything before I buy so I do the same for the buyers