562xp Hesitation Question

[Junkfxr]

Nope, if it's running like you want it to, run the snot out of it. When they start causing you more headache and money than they're worth, then throw the junk heap away.

 

[Hedgerow]

not to mention the top end on hedgerows saw was ported before it ever saw the first tank of fuel.

And it eats that no good, thin Lucas oil.
Lol..

 

[Mastermind]

And it eats that no good, thin Lucas oil.
Lol..

All the A/T and M/T saws seem to like the thinner oils. I use Yamalube 2R because it's purple. I like purple oil.

 

[zogger]

All the A/T and M/T saws seem to like the thinner oils. I use Yamalube 2R because it's purple. I like purple oil.

Pretty soon they will have optical sensors and not run at all except with the approved factory oil or canned premix..and it will data record everything so the dealer can go AH HAH! and deny warranty claims...just sayin...

 

[CristiRo]

Hello guys!
Wich is the best fix for an EL47 that dies when hitting the trigger?
I do not have a off idle problem, just when hitting the trigger it dies.
Reducing the pop-off pressure will help?
Or i need to make larger holes in the throtle plate?

 

[ash man]

El-48 carb did the trick for my 2260

 

[CristiRo]

El-48 carb did the trick for my 2260

Thanks!
Just spoke to a local dealer and he said to me that they only have for order the EL44 carb.
I'm looking for a fix, for this EL47 for now...
I'm not thinking for a carb swap right now, but i'll take this in consideration.
Anybody knows what carb is on the 2017 562xp?

 

[DND 9000]

Current carb on the 562xp is the (ZAMA 140055A), introduced from serial no.: 20160800193

 

[CristiRo]

Thanks!
Rotating the butterfly could help resolve that shut off when hitting the trigger while idling?

Just to show the issue I have, after idling a bit:

 

[Little Al]

Well, I haven't been able to run it much, because of my health issues....

Well Troll it can be any make if it's not running it will not have idling /acceleration problems

 

[CristiRo]

So, I took of the carb and this is the butterfly.
What hole should I make bigger?