Working on a saw my grandpa gave me. It’s a 94. The piston was smoked so I have a new meteor on the way as well as the other missing pieces. Included is a brake bar off a 266 that I’ll just trim the 266 panel or strip it down and put the guts in the Jred panel...brake bar is cracked half way through.
Biggest question I have....
Are the cylinder bolts on the Jonsered the same size as the 266?
When I ran the part number off the Jonsered parts diagram it comes up as a Husqvarna part. I read the screw/bolt on the 266 was a bit smaller.
this is the part number from the diagram for the 630. It looks correct, but doesn’t state thread size ect. At $5/each I want 4 that are correct. Thanks..503216025 https://www.ereplacementparts.com/screw-p-614917.html