ArboristSite.com Sponsors
 
 


Another Foredom question

Discussion in 'Hot Saws' started by Kronk, Aug 30, 2018.

  1. Kronk

    Kronk ArboristSite Lurker

    Joined:
    May 7, 2015
    Messages:
    15
    Likes Received:
    4
    Location:
    Nebraska
    I would like to know if this would be a decent setup for beginning exhaust and intake port work. Also, this is available in 4mm and 5mm versions for the same price. What do you guys think?[​IMG][​IMG][​IMG]

    Sent from my SM-G965U using Tapatalk
     
  2. cus_deluxe

    cus_deluxe Thats what she said.

    Joined:
    Apr 6, 2014
    Messages:
    3,951
    Likes Received:
    4,674
    Location:
    Northern Lower Michigan
    As long as that chuck will tighten down enough to accept 3mm/1/8” shank burrs that would be a good start. I bought the harbor frieght flex shaft kit for about $50, works great but is not reversible, which i think this is.
     
    mdavlee likes this.
  3. cus_deluxe

    cus_deluxe Thats what she said.

    Joined:
    Apr 6, 2014
    Messages:
    3,951
    Likes Received:
    4,674
    Location:
    Northern Lower Michigan
    Theres a blue SR motor kit too, not sure what the difference is between the two.
     

Share This Page