HI, Im trying to start my Talon small chainsaw and tune it up to cut better.
I have read about the Idle screw , the H and L screws.
My saw starts on full throttle and after a minute or 3 of warm up I try to go to 'run' mode' . When I get from Full choke to Half Choke it revs really fast and then when I move to normal run IT just dies. Stops dead.
The H and L have been wound all the way in and back 1 full turn.
Any ideas where I should start to fix the start issue?
I have read about the Idle screw , the H and L screws.
My saw starts on full throttle and after a minute or 3 of warm up I try to go to 'run' mode' . When I get from Full choke to Half Choke it revs really fast and then when I move to normal run IT just dies. Stops dead.
The H and L have been wound all the way in and back 1 full turn.
Any ideas where I should start to fix the start issue?