Steven Trexler
ArboristSite Guru
Just picked these saws up the other day and now looking to pass them on.
First off is a project 034 is missing some parts and is pretty dirty as you can see in the picture. There is a little scoring but I don't think its bad enough the cylinder wont clean up. Also one bar stud is stripped I believe which is why it's missing. What you see in the pictures is all I got with it. I'd like $35 plus shipping.
Second is another project 034 the top end on this one looks great. The holes on the gas tank that the handle mounts to are stripped. What's in the picture is what you get. I'd like $35 plug shipping for this one also.
Third is an 025 project that looks almost like it was dropped or tree fell on it and messed up plastics. The top end is immaculate but crank bearings feel a little tight. I'd like $30 plus shipping for this one.
Lastly I have a complete 034 that runs but does have a little bit of carbon scuffing on piston. Saw will probably need carb cleaning because it won't really idle that well or at least went through to pin point the cause of the no idle. Will get compression and piston pictures tomorrow. I would like $120 plus shipping for this saw.
As always PM with question and/or comments. Pictures are to follow so bear with me. Thanks.
First off is a project 034 is missing some parts and is pretty dirty as you can see in the picture. There is a little scoring but I don't think its bad enough the cylinder wont clean up. Also one bar stud is stripped I believe which is why it's missing. What you see in the pictures is all I got with it. I'd like $35 plus shipping.
Second is another project 034 the top end on this one looks great. The holes on the gas tank that the handle mounts to are stripped. What's in the picture is what you get. I'd like $35 plug shipping for this one also.
Third is an 025 project that looks almost like it was dropped or tree fell on it and messed up plastics. The top end is immaculate but crank bearings feel a little tight. I'd like $30 plus shipping for this one.
Lastly I have a complete 034 that runs but does have a little bit of carbon scuffing on piston. Saw will probably need carb cleaning because it won't really idle that well or at least went through to pin point the cause of the no idle. Will get compression and piston pictures tomorrow. I would like $120 plus shipping for this saw.
As always PM with question and/or comments. Pictures are to follow so bear with me. Thanks.
Attachments
-
2015-02-09_16-30-38_596.jpg60.6 KB · Views: 94
-
2015-02-09_16-30-30_53.jpg74.9 KB · Views: 99
-
2015-02-09_16-30-20_647.jpg40.3 KB · Views: 95
-
2015-02-09_16-30-15_95.jpg75.6 KB · Views: 94
-
2015-02-09_16-30-02_520.jpg75.1 KB · Views: 94
-
2015-02-09_16-29-43_647.jpg83.2 KB · Views: 93
-
2015-02-09_16-29-31_79.jpg88.5 KB · Views: 95
-
2015-02-09_16-29-21_630.jpg45.6 KB · Views: 93
-
2015-02-09_16-29-11_303.jpg73.9 KB · Views: 94
-
2015-02-09_16-29-04_279.jpg74.6 KB · Views: 84