Craftsman Clutch Removal Tool

[Scoobaru92]

Hi everyone,
Looking for the right tool to remove this clutch assembly so I can get to the oiler. It's leaking pretty bad but I can't find the proper tool for this 3 legged clutch. If there are any cross referenced part numbers for this model please let me know.
Model: 316.380160
42cc. 2 cycle.


Any info would be great. Thanks!

 

[AnthemBassMan]

Here’s a clutch tool for an Echo that looks like it would work just fine.

https://www.amazon.com/EngineRun-Re...9Y2xpY2tSZWRpcmVjdCZkb05vdExvZ0NsaWNrPXRydWU=

L8R,
Matt

 

[Brent Nowell]

Here’s a clutch tool for an Echo that looks like it would work just fine.
View attachment 829865
https://www.amazon.com/EngineRun-Re...9Y2xpY2tSZWRpcmVjdCZkb05vdExvZ0NsaWNrPXRydWU=

L8R,
Matt

Will work!

 

[Scoobaru92]

Here’s a clutch tool for an Echo that looks like it would work just fine.
View attachment 829865
https://www.amazon.com/EngineRun-Re...9Y2xpY2tSZWRpcmVjdCZkb05vdExvZ0NsaWNrPXRydWU=

L8R,
Matt

Thank you for your help! Got it ordered today.

 

[AnthemBassMan]

You’re welcome. Always nice to have the correct tool for the job.

L8R,
Matt

 

[Goofaroo]

If you want to go ahead and take it apart you can just chase it off of there with a drift and a small hammer. Just lock the cylinder and remember that it is a left hand thread.

 

[Jasonrkba]

I think i used a spanner wrench for my side grinder one time.

 

[Scoobaru92]

You’re welcome. Always nice to have the correct tool for the job.

L8R,
Matt

Just a heads up that part doesn't fit right off the rip, the teeth are a little too fat. I took a dremel with a grinding wheel on it to them, and was able to get them down to size without removing much material. Just thought I'd let you know for the next guy.
Thanks again

 

[Foregly]

You can do this without tools. Just watch on Youtube related this. Here are few video to learn this. If you want to buy then search on amazon for your requirement.