I have a Dayton 4Z252 which is the same as a Poulan 5200. Very nice low hour saw, way less than normal paint missing, good spur drive sprocket (I think the one it came with), a very nice original 24" bar in very good shape with a good chain. I have gone through the fuel system and replaced all the lines, installed new carb kit, cleaned the carb, a new fuel filter, and new seals were installed about 4 years ago . It needs nothing and is a 100% mechanical saw and about 96% on cosmetics. I will include a new rim drive setup for the new owner. I have taken this to some GTG's and that is all, never did I use it for work in the 5 years I've owned it. In 5 years it may have 2 hours of run time from me and I'm betting a lot less. $625 with the buyer paying 1/2 the ride in the lower 48. Anywhere else and we can negotiate the shipping.