Did I do okay for $120$

[RED-85-Z51]

I think i did okay [emoji6]

Sent from my LM-G820 using Tapatalk

 

[jltrent]

You basically stole it. Good find....

 

[Dean-O]

Very clean 026. Great purchase

 

[RED-85-Z51]

Runs like a champ too. Its sat most of its life...owner indicated its the original bar..even still has the weird little scrench too.

Sent from my LM-G820 using Tapatalk

 

[alderman]

Looks like a winner to me. Will make you feel good every time you run it.


Sent from my iPhone using Tapatalk

 

[mexicanyella]

Used to work for a golf course with a lot of wooded area and the maintenance department had two of those, and an 044. The 026s never seemed to need anything but fuel, oil and chain maintenance and seemed like really nice saws to operate to me. $120 sounds like some heavy “right place at the right time” action; congrats!

 

[660catman]

Excellent find. Gotta love an 026!!

 

[RED-85-Z51]

Can someone enlighten me as to the secret of the filter cover? It slides on fine...but the knob doesnt really turn...when it does it's cocked at an angle.

Sent from my LM-G820 using Tapatalk

 

[660catman]

That’s just how they are.

 

[RED-85-Z51]

I think i figured it out. Captures behind the studs, i slide it down, push in some and turn ccw about 40* and it holds firmly...and the knob is straight.

Sent from my LM-G820 using Tapatalk

 

[johnathan88]

That’s nice I’d like to have a 026 myself

 

[660catman]

I think i figured it out. Captures behind the studs, i slide it down, push in some and turn ccw about 40* and it holds firmly...and the knob is straight.

Sent from my LM-G820 using Tapatalk

So I had to try mine again this morning. Made no difference until I pushed the cover down a bit then turned knob. Didn’t matter CCW or CW. It’s straight now. All these years without it being correct. I guess only one tab was grabbing to make it crooked

 

[RED-85-Z51]

So I had to try mine again this morning. Made no difference until I pushed the cover down a bit then turned knob. Didn’t matter CCW or CW. It’s straight now. All these years without it being correct. I guess only one tab was grabbing to make it crooked

That's the only thing i could figure. Its dodgy but it works, all the little diamond shaped part does is turn between the posts.

Sent from my LM-G820 using Tapatalk

 

[Mad Professor]

Deserves a You suck!!!

Nice find. Looks to have both Hi/Lo carb screws too

 

[RED-85-Z51]

Deserves a You suck!!!

Nice find. Looks to have both Hi/Lo carb screws too

It does indeed. Turned her up this morning...she screams

Sent from my LM-G820 using Tapatalk

 

[Bob Hedgecutter]

Typical orange and grey saw- it need incontinence pads where it sleeps.
$120 of yours ($196 of ours) is getting up there when compared to the 024 Super I picked up the other day for $20 of ours ($12:20 of yours).