Get that muff modded, a lot of gain if opened up good. Steve
Echo cs-352
- Thread starter Horrigan72
- Start date
Help Support Arborist Forum:
Horrigan72
ArboristSite Member
That's my plan. I will update when I'm done.
Sent from my SM-G970U using Tapatalk
Sent from my SM-G970U using Tapatalk
Flint Mitch
ArboristSite Guru
Get u a torch, heat up the rolled over crimped edge on the muffler cherry red. That steel is now quite soft. Use a chisel or something similar to open up that rolled edge and your there. You'll have to do a little grinding once inside to remove the cat. Once done you can re assemble and tap the rolled edges back over. Takes 15 minutes. Make sure you reuse the original spacers internally to keep the muffler from crushing when tightening or go to the hardware store and get some steel spacers. I believe 1.5" long. You'll have to measure for sure. That's a good running saw after your done!
Sent from my SM-G981U using Tapatalk
Similar threads
