Sold Husqvarna 357xp with 20"Oregon bar and chain

[Brandon owenby]

Husqvarna 357xp the starter assembly says 359 but it was just a replacement. Great running does have a big bore cylinder kit in it that really throws the chips but I will also include the OEM cylinder and piston the cylinder. It has not what you would call gouged but kinda scratches not through the nikasil.The top cover is from a 359. Other than the big bore kit and my homemade fellings everything is oem. I want $475 message me or call (828)676-4703 I

 

[cuinrearview]

You will probably want some closer, higher resolution photos of all sides of the saw cleaned up Brandon. Also a close up picture of the ring and piston through the exhaust and/or a pic of a compression test. I've sold saws without any of that but I've been at it for a minute, and I've had a lot more people ask for them through PM when I didn't add them. Good luck with the sale. Are there any trades you're looking for?

 

[Brandon owenby]

Oh wow yeah I I have not thought about that thank you. I'm not too sure maybe if someone had a couple higher bigger cc or professional project saws I might. I just started to mess with Saul's not long ago but Dunn mechanics all my life that are Construction and right now this is my only form of income so I would probably be alright with trading my one good song for a couple professionals or a larger CC saws that need work.

 

[Brandon owenby]

It was pointed out that you guys might like a bit closer up pictures and a compression check. One pull 90 second pull 120 the bar is a Oregon but might need a new tip before too long stihl chain the OEM 357xp cylinder and piston goes with it but it's a great running saw all original Husqvarna parts besides the aftermarket big bore cylinder and piston. The bar and chain and the spikes I made.

 

[cgraham1]

One pull 90 second pull 120

The proper way to check compression is to keep pulling the cord until the gauge stops going up...

 

[romad10]

The proper way to check compression is to keep pulling the cord until the gauge stops going up...

SPOT ON.. DONT STOP UNTIL
1. your shoulder gives out from pain
2. your shoulder gives out from pain

 

[cgraham1]

SPOT ON.. DONT STOP UNTIL
1. your shoulder gives out from pain
2. your shoulder gives out from pain

If that happens on a 357xp...

I did have a 288xp once that was really not fun to pull over... much worse than my ported 288 that I currently have. Go figure.

 

[romad10]

If that happens on a 357xp...

I did have a 288xp once that was really not fun to pull over... much worse than my ported 288 that I currently have. Go figure.

Ive got a few 2101xps here. As you know, no decomp... Good shoulder test.. Not cool :/

Sent from my VS995 using Tapatalk

 

[cgraham1]

Ive got a few 2101xps here. As you know, no decomp... Good shoulder test.. Not cool :/

Yeah I had a 2100 once, but sadly not anymore...

357xp is a good saw. Kinda wish I still had my ported one.

 

[Brandon owenby]

Gotcha