Sold Husqvarna 362xp,365xp,365xt or 372xt you pick

[Deleted member 117362]

Saw is fairly complete except for top end needs to be installed and finished. As you can see I have all parts needed for any of the builds. Take off new 2166 (365XT) p/c is in the mail, headed this way. All other combs will have new caber ring or rings installed. You can pick how to complete, p/c choice, base gasket choice (no gasket, thin aluminum, or stock). Case is from a 365sp, clutch side has double gussets. New oem case gasket and crank seals. New SKF (italy) case bearings. New fuel line, impulse line and fuel filter. Clutch is used oem and smooth. Muffler has been opened up under stock deflector. Top covers are all in nice condition and depending how it's completed, will either be high or low top. Going to wait until I receive 2166 p/c (can remove and may remove baffles) to finish. Your choice to complete 362xp or 365xp $300, 372xt $350, 2166 to 372xt $400, prices plus actual shipping cost.

 

[BGE541]

That’s a steal

 

[Deleted member 117362]

Mail came.

 

[DoB]

PM sent

 

[fulladirt]

Dang it, knew I shouldn't of ate dinner...
Best idea for f/s thread I ever saw btw!

 

[cuinrearview]

Very nice post Rex

 

[Deleted member 117362]

Very nice post Rex

Thanks, Tim. Which one would you have me build?

 

[cuinrearview]

Thanks, Tim. Which one would you have me build?

If that 48mm is closed port I'd choose that, unless you'd let me send you the NIB OE 50mm I have on the shelf.

 

[Deleted member 117362]

If that 48mm is closed port I'd choose that, unless you'd let me send you the NIB OE 50mm I have on the shelf.

I made one of those for myself.

 

[cuinrearview]

Looks great! Multi-colored just like I like em. The wide grey clutch cover completes the look.

 

[Deleted member 117362]

Looks great! Multi-colored just like I like em. The wide grey clutch cover completes the look.

Compression is low at 210.

 

[dustinwilt68]

Curious what the new owner decided on for too end? 48mm closed port would have been my choice

 

[Lionsfan]

Curious what the new owner decided on for too end? 48mm closed port would have been my choice

That's the 365 special, correct?

 

[dustinwilt68]

Yes sir, I have a few of them

 

[Lionsfan]

I've owned a 371 and an x-torque, but never a special. Why do you prefer that model?

 

[dustinwilt68]

They really pull hard and last forever, I attribute some of it to the lighter weight of the 48mm piston

 

[Deleted member 117362]

Curious what the new owner decided on for too end? 48mm closed port would have been my choice

365 is what I finished building and will test run it around 2pm.

 

[Lionsfan]

365 is what I finished building and will test run it around 2pm.

Let us know how it stacks up to that 372 oe you just finished.