Want to Trade Husqvarna 372xp xtorq

[brad ruch]

Got a 372 xtorq I rebuilt.lots of new parts.bearings,seals,piston,rings,fuel line,air filter,and throttle cable.still needs to be broke in.I'm interested in a 60cc saw.this is way more than I need.

Sent from my VS988 using Tapatalk

 

[chipper1]

Brad's a great guy, and this saw is a ripper.
Brad you used the better bearings on the bottom end correct.
Hope you get what your looking for .

 

[brad ruch]

Brad a great guy, and this saw is a ripper.
Brad you used the better bearings on the bottom end correct.
Hope you get what your looking for .

Yes steel cage bearings.thx

Sent from my VS988 using Tapatalk

 

[brad ruch]

Forgot to add the intake is gutted also.

Sent from my VS988 using Tapatalk

 

[chipper1]

Yes steel cage bearings.thx

Sent from my VS988 using Tapatalk

That's what I though you had said.
To me once that is done there is nothing to make someone judge the xtorq as a lesser saw than an oe.

Forgot to add the intake is gutted also.

Sent from my VS988 using Tapatalk

And the muffler mod as well as base gasket delete right ?

 

[brad ruch]

I put a base gasket back on.squish was a little low with the new meteor piston.

Sent from my VS988 using Tapatalk

 

[jr27236]

Nice saw, so are you looking to do a straight trade? Or I would suppose it may be some cash on top depending on saw?? I will pass the word around, GL.

 

[rushinrio12]

GLWS

 

[brad ruch]

Nice saw, so are you looking to do a straight trade? Or I would suppose it may be some cash on top depending on saw?? I will pass the word around, GL.

Yeh just straight trade.

Sent from my VS988 using Tapatalk

 

[cuinrearview]

Isn't that a 555 in your avatar pic?

 

[brad ruch]

Isn't that a 555 in your avatar pic?

Its a 545[emoji1]

Sent from my VS988 using Tapatalk

 

[cuinrearview]

Do you have a particular 60cc saw in mind?

 

[brad ruch]

Hmmm for sure a 562 or a 2260 jred.maybe a dolmar 6100.

Sent from my VS988 using Tapatalk

 

[cuinrearview]

Dolly 6100 is on my list of saws to try. I have a soft spot for their 50cc saws, I have yet to hear a complaint about the 6100.

 

[Big Block]

 

[brad ruch]

Trade pending.

Sent from my VS988 using Tapatalk

 

[brad ruch]

Saw is traded.thx

Sent from my VS988 using Tapatalk

 

[jr27236]

Saw is traded.thx

Sent from my VS988 using Tapatalk

What did you trade for? If you dont mind me asking.