I am just finishing a rebuild on a 395xp and have some concerns about the flywheel side crank seal. I haven't been able to locate a service manual for the 395, but have a manual for the 394. It says to recess the seal 5mm from the outer machined edge of the case. This seems rather deep. Does anyone have any good info on this, or better yet pictures of a properly installed seal.
Husqvarna 395xp crank seals
- Thread starter JakeHobbs
- Start date
-
- Tags
- 395 crank seals
Help Support Arborist Forum:
husky saws often require countersinking the seal depths to prevent the flywheel
from digging into the seal .My 181se lists 3.5 mil below pocket
