So I have a husqvarna 435 and I'm trying to get more power out of it so far I've done a MM on it and seen some top end results but it still needs more. Just wondering if anyone has ported one or done a big bore swap on one
Husqvarna 435
- Thread starter Ratliff36
- Start date
Help Support Arborist Forum:
Welcome to AS Ratliff.
Not sure if you're looking to buy one or looking for information on building one.
Brett
Not sure if you're looking to buy one or looking for information on building one.
Brett
Sounds like a project.
There are a few guys who have done some of the clamshell saws up into something fun.
@pioneerguy600 could you move this to the chainsaw forum.
This is the Trading Post where guys buy and sell saws
.
There are a few guys who have done some of the clamshell saws up into something fun.
@pioneerguy600 could you move this to the chainsaw forum.
This is the Trading Post where guys buy and sell saws
.
floriceeel
ArboristSite Member
I did a light port job on it, timing advance and a MM. Used it with a 13'' b&c and the saw rips. Do it !
