JonCutter bars

[Joseph W Santora]

I've got one of their 25cc "Prowler Puppy's" and it's a hoot. Does anyone know what bar I can put on it mount wise, other than the one it cam with?

Joe

 

[NSEric]

I have a bar for a 3314 poulan on my Chinese 25cc saw, it fits fine without mods.

 

[fishercat]

I use factory bars and make two exceptions.

 

[buttercup]

Oregon have bars and chains that fit, it's tha famous Zenoa design- widely licensed to all sorts of brands. Oregon 91 chains as I recall.

 

[Huskybill]

Your not using the huztl / farmtec joncutter bars?

I’ve seen the cost for changing bars, chains, drive sprockets at the shops. The cost at huztl / farmtec is far cheaper. The bar n chain combos are silly cheap. I think I purchased four chains for $6 each.

 

[NSEric]

In my case I had the little poulan bar/chain already.
My 25cc saw isn't a joncutter but it's the same Chinese saw in a different color. It came with a 12 inch bar and a really crappy chain, the cutters are different heights, after a few sharpening's its was useable but it dulls really fast.

I can also get a Laser bar/chain cheaper locally than a bar/chain from huztl.