M-tronic responded well to MM

[regulate34]

Well after about 25-30 tanks threw my ms362cm. I decided to open the muffler up.

I thought I could wait till warranty ran out. Hahhaha. Made it 2 weeks.

Did the carb reset and cut some cookies. Sounds nice and definitely holds higher Rpm in the cut.

Well today at work we had some oversized Fir that need to be bucked to length.

I had my 460 with me. But decided to get the new little saw a go with the 28” tsumra and a skip chain.

Buried that bugger in the log and it just kept singing. Even with doggs dug in and light pressure it didn’t bog out.

Pretty impressed for a 60cc.

Bar was getting a tad warm. Dont think the Oiler keeps up with a buried 28”.

I’ll try to get a pic of the MM

 

[regulate34]

Simple and clean
But effective
Put a 1/2” hole kiddy corner to the OEM. Hole.

Screen intact

 

[Justin Taylor]

Nice if that saw ever needs to go back for some warranty work I got an extra stock one

 

[regulate34]

Nice if that saw ever needs to go back for some warranty work I got an extra stock one

Pm
Me some
Details if you want to sell it

 

[gmctyphoon]

When you get the bug to work on the saw again, take 20/1000 off the flywheel key (about 1/3 of the key). Advances the timing and the 362c likes it. YouTube will help or numerous threads on this site.

 

[regulate34]

When you get the bug to work on the saw again, take 20/1000 off the flywheel key (about 1/3 of the key). Advances the timing and the 362c likes it. YouTube will help or numerous threads on this site.

I was wondering about a timing advance.

Works good without porting ?