Morbark Feed Roller inop

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

TreeBob60

New Member
Joined
Sep 17, 2020
Messages
3
Reaction score
1
Location
Bluffton
2011 Morbark M18rx chipper.
I have no movement forward or reverse on feed wheel
Tach is working properly as far as I know. Shows all functions.
Fuse is good.
Replaced coil pack assy. after noticing coil was getting hot and blowing fuse.
Have voltage to coil.
Why is it not working?
 
2011 Morbark M18rx chipper.
I have no movement forward or reverse on feed wheel
Tach is working properly as far as I know. Shows all functions.
Fuse is good.
Replaced coil pack assy. after noticing coil was getting hot and blowing fuse.
Have voltage to coil.
Why is it not working?
Have you looked into the hydraulic pressure?
 
no how do I do that
everything else works great such as hydraulic that lifts feed wheel
You would need to put a hydraulic pressure gauge on the lines to isolate which section has a problem if any. Your morbark dealer might be able to hook you up with a hydraulic schematic if you give them the sn (usually located on the tongue) or the last 5 of the vin. Otherwise just trace the lines from the pump attached to engine.
 
I have it at my Morbark rep now. He does not seem to be able to figure out what the problem is. I will pass along this info. Thanks
 
Back
Top